Merritt Final Drive Freecoaster Axle

Replacement axle for the Final drive freecoaster hub, fits LHD or RHD

Any adjustments to the hub should be done by a professional. A cone wrench MUST be used to disassemble/reassemble the hub. Damaged caused by you not knowing what you’re doing isn’t covered by warranty. To reinstall the driver and hardware properly make sure the driver is fully inserted into the hub and clutch is disengaged from hub. Hand tighten the inner cone-nut until it contacts the driver bushing, then loosen 1/4 turn. While holding the inner cone-nut in position (21mm cone wrench), tighten the locking cone-nut against it. If you have a torque wrench, tighten to 20 lb-ft.